Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problem saving poses
#1
Greetings, I'm relatively new to Frameforge. I'm trying to save a pose called "applause" - just a male actor clapping. I pose the figure, then select "arms, both" from the stored poses, then I press the "Store current position..." button and save the pose as "applause". The new "applause" pose now appears in the list of poses under "arms, both". So far so good. But when I try to apply the new pose to a new male actor, nothing happens. I'm running Mac OS X version 10.4.11 on a PowerBook G4.

Any suggestions?
Reply
#2
Selection "arms, both" just sets where the pose will appear in the menu. The more important thing is to set the correct red dots in the bone diagram, as shown below.


Attached Files Thumbnail(s)
   
Reply
#3
D'oh! I didn't realize the red dot was the 'on' position. I assumed they were all 'off' by default. Thanks for helping out the newby jamesw.

Cheers!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)