02-09-2007, 03:20 PM
David
In the Green room under the posing tab the two ebjects labeled lower bed frame and upper bed frame are not visible. They are the legs of the original bed object I made this from. The opacity is turned all the way off on those to make them invisibile. So they are moving but you cannot see them. They are only the legs for the bed frame I used for the two pieces of the mattress. If you select the red hinge the upper portion of the bed should adjust. That was the only part of the bed I needed to move for my storyboard so I did not try to figure out how to make anything else move. Hope this still works for your project.
And no it is not made from the gurney although I used the same frameforge objects and principle to construct it. The bed is wider than the gurney and the gurney is not hinged at all. And the samething is true about the two objects not being visible on either the gurney or bed. If you want to see them you will have to go under the textures tab and selevt the bed frame metal and turn the opacity back up. Although it will make the bed or gurney look weird with the legs showing 2 feet off the floor
I hope this answers your question
In the Green room under the posing tab the two ebjects labeled lower bed frame and upper bed frame are not visible. They are the legs of the original bed object I made this from. The opacity is turned all the way off on those to make them invisibile. So they are moving but you cannot see them. They are only the legs for the bed frame I used for the two pieces of the mattress. If you select the red hinge the upper portion of the bed should adjust. That was the only part of the bed I needed to move for my storyboard so I did not try to figure out how to make anything else move. Hope this still works for your project.
And no it is not made from the gurney although I used the same frameforge objects and principle to construct it. The bed is wider than the gurney and the gurney is not hinged at all. And the samething is true about the two objects not being visible on either the gurney or bed. If you want to see them you will have to go under the textures tab and selevt the bed frame metal and turn the opacity back up. Although it will make the bed or gurney look weird with the legs showing 2 feet off the floor
I hope this answers your question